R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Configuration Guide

24
Ste
p
Command Remarks
3. Specify a card to process
and forward traffic for the
interface.
service slot slot-number
By default, traffic on a Layer 3 aggregate
interface whose member ports are located on
the same card is processed and forwarded by
the card that houses the member ports, and
traffic on a Layer 3 aggregate interface whose
member ports are located on different cards is
processed and forwarded by the card that
houses the first selected member port.
Enabling link state traps for an aggregate interface
You can configure an aggregate interface to generate linkUp trap messages when its link goes up and
linkDown trap messages when its link goes down. For more information, see Network Management and
Monitoring Configuration Guide.
To enable link state traps on an aggregate interface:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enable the trap function
globally.
snmp-agent trap enable [ standard
[ linkdown | linkup ] * ]
Optional.
By default, link state trapping is
enabled globally and on all
interfaces.
3. Enter aggregate interface
view.
• Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
• Enter Layer 3 aggregate interface
view:
interface route-aggregation
interface-number
Use either command.
4. Enable link state traps for
the aggregate interface.
enable snmp trap updown
Optional.
Enabled by default.
Setting the expected bandwidth for an aggregate interface
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter aggregate interface
view.
• Enter Layer 2 aggregate interface view:
interface bridge-aggregation
interface-number
• Enter Layer 3 aggregate interface view:
interface route-aggregation
interface-number
Use either command.