R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

137
Syntax
timer hold seconds
undo timer hold
Default
The parameter is 10 seconds.
Views
Interface view
Default command level
2: System level
Parameters
seconds: Value of T391 parameter at DTE side, which is in the range of 0 to 32767 in seconds. 0
indicates that the LMI protocol is disabled.
Usage guidelines
The parameter is a time variable that defines the interval at which the DTE sends Status-Enquiry
messages.
Examples
# Configure that frame relay interface Serial 2/0/0 to operate in DTE mode, and set the value of T391
parameter to 15 seconds.
<Sysname> system-view
[Sysname] interface serial 2/0/0
[Sysname-Serial2/0/0] link-protocol fr
[Sysname-Serial2/0/0] fr interface-type dte
[Sysname-Serial2/0/0] timer hold 15
Related commands
fr lmi t392dce
MFR configuration commands
bandwidth
Use bandwidth to set the intended bandwidth for an MFR interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
MFR interface view
Default command level
2: System level