R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

15
Table 8 Command output
Field Descri
p
tion
current state
Physical state of the interface:
• DOWN—The interface is physically down (possibly because no
physical link is present or the link has failed).
• UP—The interface is physically up.
Line protocol current state Link layer state of the interface: UP or DOWN.
Description Interface description.
The Maximum Transmit Unit Maximum transmission unit (MTU) of the interface.
Internet protocol processing
Processing state of the network layer protocol: enabled or
disabled.
IP Packet Frame Type Encapsulation format for IPv4 packets.
Hardware Address MAC address of the interface.
IPv6 Packet Frame Type Encapsulation format for IPv6 packets.
Physical is EoPW
The physical state of the interface is Ethernet over Pseudo Wire
(EoPW). This field is displayed only when you configure the VE
interface to connect an MPLS L2VPN to an MPLS L3VPN.
baudrate
Maximum bandwidth of the interface. This field is displayed only
when you configure the VE interface to enable an MPLS L2VPN to
access an MPLS L3VPN.
Link service is PWE3 ethernet mode
Ethernet mode of the link PWE3. This field is displayed only when
the VE interface is connected to an MPLS L2VPN.
Link service is PWE3 ethernet tagged
mode
VLAN mode of the link PWE3. This field is displayed only when the
VE interface is connected to an MPLS L2VPN.
Output queue : (Urgent queue :
Size/Length/Discards)
Output queue : (Protocol queue :
Size/Length/Discards)
Output queue : (FIFO queuing :
Size/Length/Discards)
Packet statistics for the following output queues:
• Urgent queues.
• Protocol queues.
• FIFO queues.
Last clearing of counters: Never
Time when the reset counters interface command was last used to
clear the interface statistics. Never indicates the reset counters
interface command has never been used on the interface after the
device has started up.
Last 300 seconds input: 0 bytes/sec 0
packets/sec
Last 300 seconds output: 0 bytes/sec 0
packets/sec
Average input or output rate over the last 300 seconds in bps and
pps. This field is displayed only when the interface supports traffic
accounting.
0 packets input, 0 bytes, 0 drops
Statistics on the packets received. This field is displayed only when
the interface supports traffic accounting.
0 packets output, 0 bytes, 0 drops
Statistics on the packets sent. This field is displayed only when the
interface supports traffic accounting.
The brief information of interface(s) under
route mode:
Brief information about Layer 3 interfaces.