R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

55
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
If you do not specify the virtual-template keyword, this command displays information about all
interfaces on the device.
If you specify the virtual-template keyword without the number argument, this command displays
information about all existing VTs.
Examples
# Display detailed information about VT 1.
<Sysname> display interface virtual-template 1
Virtual-Template1 current state: UP
Line protocol current state: UP (spoofing)
Description: Virtual-Template1 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet Address is 6.1.1.2/8 Primary
Link layer protocol is PPP
LCP initial, MP opened
Physical is None, baudrate: 64000 bps
Output queue : (Urgent queuing : Length) 100
Output queue : (Protocol queuing : Length) 500
Output queue : (FIFO queuing : Length) 75
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
512 packets input, 43008 bytes, 0 drops
614 packets output, 49636 bytes, 0 drops
# Display brief information about VT 1.
<Sysname> display interface virtual-template 1 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
VT1 UP UP(s) --
See Table 11 for the output description.
Related commands
interface virtual-template
display ppp mp
Use display ppp mp to display the information about an MP interface.