R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - WAN Configuration Guide

18
Step Command Remarks
1. Enter system view.
system-view N/A
2. Create a VT interface.
interface virtual-template
vt-number
Configure PPP authentication and
an IP address on the VT interface
(the IP address is invalid if
configured on the ATM interface).
3. Set the PPP authentication
mode and IP address; with the
PPPoE server, an address pool
should be configured to
allocate IP address for the
peer end; with the PPPoE
client, address negotiation
should be configured to
accept the IP address
allocated by the server end..
See "Configuring PPP and MP." N/A
4. Return to system view.
quit N/A
5. Create a VE interface.
interface virtual-ethernet
interface-number
N/A
6. Configure PPPoE parameters
on VE interface (the
configuration differs when
with a PPPoE server and when
with a PPPoE client).
See "Configuring PPP and MP." N/A
7. Return to system view.
quit N/A
8. Enter ATM interface view.
interface atm { interface-number |
interface-number.subnumber }
N/A
9. Create a PVC, and enter the
PVC view.
pvc { pvc-name [ vpi/vci ] |
vpi/vci }
N/A
10. Create a PPPoEoA mapping
for the PVC.
map bridge virtual-ethernet
interface-number
The interface-number argument
refers to the VE interface created in
the steps.
Displaying and maintaining ATM
Task Command Remarks
Display the configuration and
status information of an ATM
interface.
display atm interface [ atm interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display information about PVCs.
display atm pvc-info [ interface interface-type
interface-number [ pvc { pvc-name [ vpi/vci ] |
vpi/vci } ] ] [ | { begin | exclude | include }
regular-expression ]
Available in any view.