R3102-R3103-HP 6600/HSR6600 Routers Layer 3 - IP Routing Configuration Guide

423

Figure 116 Network diagram

Configuration procedure

# Configure ACL 2000.

<RouterA> system-view

[RouterA] acl number 2000

[RouterA-acl-basic-2000] rule 0 permit source any

[RouterA-acl-basic-2000] quit

# Define a match criterion for class a to match ACL 2000.

[RouterA] traffic classifier a

[RouterA-classifier-a] if-match acl 2000

[RouterA-classifier-a] quit

# Configure the action of redirecting traffic to the next hop 202.1.1.2 for behavior a.

[RouterA] traffic behavior a

[RouterA-behavior-a] redirect next-hop 202.1.1.2

[RouterA-behavior-a] quit

# Associate class a with behavior a in QoS policy a.

[RouterA] qos policy a

[RouterA-qospolicy-a] classifier a behavior a

[RouterA-qospolicy-a] quit

# Apply QoS policy a to the inbound direction of GigabitEthernet 2/0/1.

[RouterA] interface gigabitethernet 2/0/1

[RouterA-GigabitEthernet2/0/1] qos apply policy a inbound

Verifying the configuration

After completing the configuration, verify that when Router A receives packets with destination IP address

201.1.1.2, it forwards the packets to Router C instead of Router B.

IPv6 QoS policy routing configuration example

Network requirements

As shown in Figure 117, redirect all packets received on GigabitEthernet 2/0/1 of Router A to the next

hop 202::2.