R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

149
Usage guidelines
The interface properties are propagated globally and are used for path selection at the tunnel ingress.
Examples
# Assign interface GigabitEthernet 2/1/1 the link administrative group attribute of 0x00000101.
<Sysname> system-view
[Sysname] interface giabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] mpls te link administrative group 101
Related commands
mpls te affinity property
mpls te loop-detection
Use mpls te loop-detection to configure the node to perform loop detection when setting up the MPLS TE
tunnel.
Use undo mpls te loop-detection to disable loop detection.
Syntax
mpls te loop-detection
undo mpls te loop-detection
Default
A node does not perform loop detection when setting up a tunnel.
Views
Tunnel interface view
Default command level
2: System level
Examples
# Configure the node to perform loop detection when setting up tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te loop-detection
mpls te max-link-bandwidth
Use mpls te max-link-bandwidth to configure the maximum bandwidth for the link to forward MPLS TE
traffic.
Use undo mpls te max-link-bandwidth to restore the default.
Syntax
mpls te max-link-bandwidth bandwidth-value
undo mpls te max-link-bandwidth
Default
The maximum link bandwidth for MPLS TE traffic is 0.