R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

150
Views
Interface view
Default command level
2: System level
Parameters
bandwidth-value: Maximum bandwidth of the link, in the range of 1 to 32000000 kbps.
Usage guidelines
The configured maximum link bandwidth is available for only MPLS TE traffic.
Examples
# On interface Serial 2/1/1, set the maximum link bandwidth for MPLS TE traffic to 1158 k b ps .
<Sysname> system-view
[Sysname] interface serial 2/1/1
[Sysname-Serial2/1/1] mpls te max-link-bandwidth 1158
mpls te max-reservable-bandwidth
Use mpls te max-reservable-bandwidth to configure the bandwidth constraints BC 0 and BC 1 in
prestandard DS-TE RDM mode.
Use undo mpls te max-reservable-bandwidth to restore the default.
Syntax
mpls te max-reservable-bandwidth bandwidth-value [ bc1 bc1-bandwidth ]
undo mpls te max-reservable-bandwidth
Default
BC 1 is 0 kbps.
Default
Both BC 0 and BC 1 is 0 kbps.
Views
Interface view
Default command level
2: System level
Parameters
bandwidth-value: Maximum reservable bandwidth of the link, or, the value of BC 0. It is in the range of
1 to 32000000 kbps.
bc1 bc1-bandwidth: Value of BC 1, in the range of 1 to 32000000 kbps.
Usage guidelines
The maximum reservable bandwidth of a link—the value of BC 0 (bandwidth-value)—cannot be greater
than the maximum bandwidth of the link, and the value of BC 1 (bc1-bandwidth) cannot be greater than
the value of BC 0 (bandwidth-value).
The bandwidth in this command is configured only for MPLS TE traffic.