R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

161
Syntax
mpls te timer auto-bandwidth [ seconds ]
undo mpls te timer auto-bandwidth
Default
Automatic bandwidth adjustment is disabled.
Views
MPLS view
Default command level
2: System level
Parameters
seconds: Interval for output rate sampling for tunnels configured with automatic bandwidth adjustment,
in the range of 1 to 604800 seconds. If it is not configured, the default of 300 seconds applies. Use the
default in normal cases.
Usage guidelines
To change the output rate sampling interval, use the undo mpls te timer auto-bandwidth command to
disable automatic bandwidth adjustment first and then use the mpls te timer auto-bandwidth command
to re-configure it.
Examples
# Collect the output rates of MPLS TE tunnels automatically every 10 seconds or 600 seconds.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te timer auto-bandwidth 600
Related commands
mpls te auto-bandwidth
mpls te timer fast-reroute
NOTE:
This command is not supported when the signaling protocol is CR-LDP.
Use mpls te timer fast-reroute to set the FRR polling timer.
Use undo mpls te timer fast-reroute to restore the default setting.
Syntax
mpls te timer fast-reroute [ seconds ]
undo mpls te timer fast-reroute
Default
The FRR polling timer is 300 seconds.
Views
MPLS view