R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

162
Default command level
2: System level
Parameters
seconds: FRR polling timer setting for the point of local repair (PLR) to poll available bypass tunnels for
the best one. The value range is 0 to 604800 seconds, with 0 disabling the PLR to poll available bypass
tunnels regularly for the best one. The default is 300 seconds or 5 minutes.
Examples
# Set the FRR polling timer to 120 seconds or 2 minutes.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te timer fast-reroute 120
mpls te timer link-management periodic-flooding
Use mpls te timer link-management periodic-flooding to configure the interval for advertising updated
bandwidth.
Use undo mpls te timer link-management periodic-flooding to restore the default.
Syntax
mpls te timer link-management periodic-flooding interval
undo mpls te timer link-management periodic-flooding
Default
The bandwidth advertisement interval is 180 seconds.
Views
MPLS view
Default command level
2: System level
Parameters
Interval: Interval for advertising bandwidth, in the range of 0 to 3600, in seconds.
Usage guidelines
The interval specified by this command is that at which the system will periodically advertise interface
bandwidth if the bandwidth changes are within the specified threshold. To set the interval to 0 means to
disable the bandwidth advertisement function. The minimal valid interval is 30 seconds. If you set the
interval to a value less than 30, the system takes 30 seconds as the interval. If you change the interval
before the current interval elapses, the new setting takes effect. For example, if you set the interval to 30
seconds, and then, within 30 seconds, set the interval to 3600 seconds, the interval of 3600 seconds
takes effect.
Examples
# Set the bandwidth advertising interval to 100 seconds.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te
[Sysname- mpls] mpls te timer link-management periodic-flooding 100