R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

169
Syntax
reset mpls te auto-bandwidth adjustment timers
Views
User view
Default command level
1: Monitor level
Usage guidelines
This command clears information about output rate sampling and the remaining time for next bandwidth
optimization.
Examples
# Reset the automatic bandwidth adjustment function.
<Sysname> reset mpls te auto-bandwidth adjustment timers
static-cr-lsp egress
Use static-cr-lsp egress to configure a static CR-LSP on the egress node.
Use undo static-cr-lsp egress to remove the static CR-LSP.
Syntax
static-cr-lsp egress tunnel-name incoming-interface interface-type interface-number in-label
in-label-value [ bandwidth [ ct0 | ct1 | ct2 | ct3 ] bandwidth-value ]
undo static-cr-lsp egress tunnel-name
Default
Static CR-LSP traffic belongs to CT 0.
Views
System view
Default command level
2: System level
Parameters
tunnel-name: Tunnel name, a case-sensitive string of 1 to 15 characters.
incoming-interface interface-type interface-number: Specifies the incoming interface.
in-label in-label-value: Specifies the incoming label, which can be a value of 0, 3, or 16 through 1023.
bandwidth: Specifies the class type (CT) for static CR-LSP traffic.
ct0: Specifies CT 0 for static CR-LSP traffic.
ct1: Specifies CT 1 for static CR-LSP traffic.
ct2: Specifies CT 2 for static CR-LSP traffic.
ct3: Specifies CT 3 for static CR-LSP traffic.
bandwidth-value: Bandwidth required by static CR-LSP traffic, in the range of 1 to 32000000, in kbps.