R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

172
bandwidth-value: Bandwidth required by the static CR-LSP, in the range of 1 to 32000000 kbps.
Usage guidelines
CT 2 and CT 3 can be used in only IETF DS-TE mode. In prestandard DS-TE mode, the configuration of
CT 2 or CT 3 is invalid, and thus the tunnel cannot be established.
The next hop address for a static CR-LSP configured on the ingress or a transit node cannot be a local
public address.
Examples
# Configure a static CR-LSP on the transit node, setting its name to tunnel34, incoming interface to Serial
2/1/1, incoming label to 123, outgoing interface to Serial 2/1/2, outgoing label to 253, CT of traffic
to CT 0, and required bandwidth to 20 kbps.
<Sysname> system-view
[Sysname] static-cr-lsp transit tunnel34 incoming-interface serial 2/1/1 in-label 123
outgoing-interface serial 2/1/2 out-label 253 bandwidth ct0 20
statistics te
Use statistics te to enable statistics collection for an RSVP-TE tunnel.
Use undo statistics te to disable statistics collection for an RSVP-TE tunnel.
Syntax
statistics te ingress-lsr-id tunnel-id
undo statistics te ingress-lsr-id tunnel-id
Default
Statistics collection is disabled for all RSVP-TE tunnels.
Views
MPLS view
Default command level
2: System level
Parameters
ingress-lsr-id tunnel-id: Specifies an RSVP-TE tunnel. ingress-lsr-id indicates the LSR ID of the ingress node
and tunnel-id indicates the tunnel ID, which is in the range of 0 to 65535.
Examples
# Enable the device to collect statistics on the RSVP-TE tunnel whose ingress node's LSR ID is 2.2.2.2 and
tunnel ID is 100.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] statistics te 2.2.2.2 100
Related commands
• display mpls statistics lsp
• display mpls statistics lsp in-label
• display mpls statistics tunnel