R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

219
undo service-instance instance-id
Default
No service instances have been created on any interface.
Views
Interface view
Default command level
2: System level
Parameters
instance-id: Specifies a service instance ID in the range of 1 to 4096.
Usage guidelines
The device can support up to 20480 service instances.
Examples
# Create service instance 1 on Ten-GigabitEthernet 1/0/1, and then enter service instance view.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] service-instance 1
[Sysname-Ten-GigabitEthernet1/0/1-srv1]
static backup-label
Use static backup-label to configure VC labels for a backup VC.
Use undo static backup-label to remove the VC labels configured for the backup VC.
Syntax
static backup-label local local-vc remote remote-vc
undo static backup-label
Default
No VC labels are configured for a backup VC.
Views
Static-L2VC view, Static-xpeer view
Default command level
2: System level
Parameters
local local-vc: Specifies the local VC label in the range of 16 to 1023.
remote remote-vc: Specifies the remote VC label in the range of 16 to 1023.
Usage guidelines
When you configure a static VC, you must manually specify VC labels for the VC. Make sure VC labels
you specify on the local device match those on the remote device.
If you do not specify the backup-peer keyword in the mpls static-l2vc command (for main-backup SVC)
or in the xconnect static-peer command, the static backup-label command will fail.