R3102-R3103-HP 6600/HSR6600 Routers MPLS Configuration Guide

136
Negotiated Keepalive Timer : 45 Sec
Keepalive Message Sent/Rcvd : 437/437 (Message Count)
Label Advertisement Mode : Downstream Unsolicited
Label Resource Status(Peer/Local) : Available/Available
Peer Discovery Mechanism : Basic
Session existed time : 000:01:48 (DDD:HH:MM)
LDP Basic Discovery Source : GigabitEthernet2/1/1
Addresses received from peer: (Count: 2)
2.1.1.1 1.1.1.1
----------------------------------------------------------------------
Peer LDP ID : 3.3.3.3:0 Local LDP ID : 2.2.2.2:0
TCP Connection : 2.2.2.2 <- 3.3.3.3
Session State : Operational Session Role : Passive
Session FT Flag : Off MD5 Flag : Off
Reconnect Timer : --- Recovery Timer : ---
Negotiated Keepalive Timer : 45 Sec
Keepalive Message Sent/Rcvd : 411/411 (Message Count)
Label Advertisement Mode : Downstream Unsolicited
Label Resource Status(Peer/Local) : Available/Available
Peer Discovery Mechanism : Extended
Session existed time : 000:01:42 (DDD:HH:MM)
LDP Extended Discovery Source : Remote peer: 1
Addresses received from peer: (Count: 2)
4.1.1.1 3.3.3.3
----------------------------------------------------------------------
Execute the display mpls ldp lsp command on Router B. The output shows that Router C sent label
mapping messages to Router B and established an LDP LSP.
[RouterB] display mpls ldp lsp
LDP LSP Information
----------------------------------------------------------------------
SN DestAddress/Mask In/OutLabel Next-Hop In/Out-Interface
----------------------------------------------------------------------
1 1.1.1.1/32 NULL/3 2.1.1.1 -------/GE2/1/1
2 2.2.2.2/32 3/NULL 127.0.0.1 -------/InLoop0
3 3.3.3.3/32 NULL/3 10.1.1.1 -------/Tun4
4 3.3.3.3/32 1024/3 10.1.1.1 -------/Tun4
----------------------------------------------------------------------
A '*' before an LSP means the LSP is not established
A '*' before a Label means the USCB or DSCB is stale