R3102-R3103-HP 6600/HSR6600 Routers MPLS Configuration Guide

139
# Configure PE 2.
<PE2> system-view
[PE2] interface loopback 0
[PE2-LoopBack0] ip address 3.3.3.3 255.255.255.255
[PE2-LoopBack0] quit
[PE2] interface pos 5/1/1
[PE2-POS5/1/1] ip address 10.0.0.2 255.255.255.0
[PE2-POS5/1/1] quit
[PE2] ospf
[PE2-ospf-1] area 0
[PE2-ospf-1-area-0.0.0.0] network 10.0.0.0 0.0.0.255
[PE2-ospf-1-area-0.0.0.0] network 3.3.3.3 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
After you complete the configuration, the PEs establish an OSPF neighbor relationship. Execute the
display ospf peer verbose command. You can see that the neighborship state is FULL. Execute the
display ip routing-table command. You can see that the PEs have learned the routes to the
loopback interfaces of each other. Take PE 1 for example:
[PE1] display ospf peer verbose
OSPF Process 1 with Router ID 2.2.2.2
Neighbors
Area 0.0.0.0 interface 10.0.0.1(POS5/1/1)'s neighbors
Router ID: 3.3.3.3 Address: 10.0.0.2 GR State: Normal
State: Full Mode:Nbr is Master Priority: 1
DR: None BDR: None
Dead timer due in 30 sec
Neighbor is up for 00:01:00
Authentication Sequence: [ 0 ]
[PE1] display ip routing-table
Routing Tables: Public
Destinations : 7 Routes : 7
Destination/Mask Proto Pre Cost NextHop Interface
2.2.2.2/32 Direct 0 0 127.0.0.1 InLoop0
3.3.3.3/32 OSPF 10 1563 10.0.0.2 POS5/1/1
10.0.0.0/24 Direct 0 0 10.0.0.1 POS5/1/1
10.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
10.0.0.2/32 Direct 0 0 10.0.0.2 POS5/1/1
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
2. Configure basic MPLS TE, and enable RSVP-TE and CSPF:
# Configure PE 1.
[PE1] mpls lsr-id 2.2.2.2
[PE1] mpls
[PE1-mpls] lsp-trigger all
[PE1-mpls] mpls te
[PE1-mpls] mpls rsvp-te
[PE1-mpls] mpls te cspf
[PE1-mpls] quit