R3102-R3103-HP 6600/HSR6600 Routers MPLS Configuration Guide

172
Configuration procedure
To create a CE connection:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS L2VPN view.
mpls l2vpn vpn-name N/A
3. Create a CE, specify the CE
name, CE ID, CE range, and
the initial CE ID, and enter
MPLS L2VPN CE view.
ce ce-name [ id ce-id [ range
ce-range ] [ default-offset
default-offset ] ]
N/A
4. Create a Kompella
connection.
connection [ ce-offset ce-id ]
interface interface-type
interface-number [ tunnel-policy
tunnel-policy-name ]
The ce-offset ce-id option
determines whether the connection
is a local connection or a remote
connection. If the specified CE is
connected to the same PE as the
local CE, the connection is a local
connection. Otherwise, the
connection is a remote connection.
The interface interface-type
interface-number option specifies a
PE-CE interface of the PE. By
specifying the interface, you bind
the AC link on the interface to the
Kompella connection.
Resetting L2VPN BGP sessions
To apply new configuration that affects BGP routing selection, perform the following task in user view:
Task Command
Reset L2VPN BGP sessions. reset bgp l2vpn { as-number | ip-address | all | external | internal }
Displaying and maintaining MPLS L2VPN
Task Command Remarks
Display information about CCC
connections.
display ccc [ ccc-name ccc-name | type
{ local | remote } ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display information about
specified L2VPN VC interfaces.
display l2vpn ccc-interface vc-type { all |
bgp-vc | ccc | ldp-vc | static-vc } [ up |
down ] [ | { begin | exclude | include }
regular-expression ]
Available in any view.