R3102-R3103-HP 6600/HSR6600 Routers MPLS Configuration Guide

183
POS5/1/1 up 192.2.2.2 200 100 -
# Ping CE 2 from CE 1. The output shows that CE 1 and CE 2 can ping each other.
[CE1] ping 100.1.1.2
PING 100.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=150 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=130 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=130 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=140 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=80 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 80/126/150 ms
Example for configuring Martini MPLS L2VPN with the VC type
of PPP
Network requirements
CEs are connected to PEs through serial interfaces, and the data link layer uses PPP.
Establish a Martini VC, so CE 1 and CE 2 can exchange Layer 2 packets across the backbone.
Figure 48 Network diagram
Device Interface IP address Device Interface IP address
CE 1 S2/1/0 100.1.1.1/24 CE 2 S2/1/0 100.1.1.2/24
PE 1 Loop0 192.2.2.2/32 P Loop0 192.4.4.4/32
S2
/
1
/
1 10.1.1.1/24 S2
/
1
/
0 10.1.1.2/24
PE 2 Loop0 192.3.3.3/32 S2/1/1 10.2.2.2/24
S2
/
1
/
1 10.2.2.1/24
Configuration procedure
1. Configure CE 1:
# Configure the link protocol type as PPP on interface Serial 2/1/0 (the interface connected to the
PE 1), and configure an IP address for the interface.
<Sysname> system-view