R3102-R3103-HP 6600/HSR6600 Routers MPLS Configuration Guide

191
[Sysname] sysname CE2
[CE2] interface serial 2/1/0
[CE2-Serial2/1/0] link-protocol ppp
[CE2-Serial2/1/0] ip address 100.1.1.2 24
[CE2-Serial2/1/0] quit
[CE2] interface serial 2/1/1
[CE2-Serial2/1/1] link-protocol ppp
[CE2-Serial2/1/1] ip address 100.2.1.2 24
# Configure IS-IS.
[CE2] isis 1
[CE2-isis-1] network-entity 10.0000.0000.0002.00
[CE2-isis-1] quit
[CE2] interface serial 2/1/0
[CE2-Serial2/1/0] isis enable 1
[CE2-Serial2/1/0] quit
[CE2] interface serial 2/1/1
[CE2-Serial2/1/1] isis enable 1
[CE2-Serial2/1/1] quit
6. Verify your configuration:
# Display VC information on PE 1. The output shows that two VCs have been established, one up
and one blocked.
<PE1> display mpls l2vc
Total ldp vc : 2 1 up 0 down 1 blocked
Transport Client Service VC Local Remote
VC ID Intf ID State VC Label VC Label
20 S2/1/0 -- up 1026 1033
30 S2/1/0 -- blocked 1027 1050
# Display the detailed VC information on PE 1. The output shows that two VCs have been
established, one up and one blocked.
<PE1> display mpls l2vc interface vlan-interface 10
***VC ID : 20
VC State : up
Destination : 2.2.2.2
Client Intf : Serial2/1/0 is up
Service ID : --
Local Group ID : 0
Remote Group ID : 0
Local VC Label : 1026
Remote VC Label : 1033
Tunnel Policy : -
Tunnel Type : lsp
Tunnel ID : 0xd2009
Local VCCV CC Type : CW, RA
Local VCCV CV Type : LSPV
Remote VCCV CC Type : CW, RA
Remote VCCV CV Type : LSPV
Backup VC