R3102-R3103-HP 6600/HSR6600 Routers MPLS Configuration Guide

294
Configuring static routing between MCE and PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure a static route
for a VPN instance.
• ip route-static dest-address { mask | mask-length }
{ gateway-address | interface-type interface-number
[ gateway-address ] | vpn-instance
d-vpn-instance-name gateway-address } [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
• ip route-static vpn-instance
s-vpn-instance-name&<1-6> dest-address { mask |
mask-length } { gateway-address [ public ] |
interface-type interface-number [ gateway-address ]
| vpn-instance d-vpn-instance-name
gateway-address } [ preference preference-value ]
[ tag tag-value ] [ description description-text ]
Use either
command as
needed.
3. Configure the default
precedence for static
routes.
ip route-static default-preference
default-preference-value
Optional.
60 by default.
Configuring RIP between MCE and PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a RIP process for
a VPN instance and
enter RIP view.
rip [ process-id ] vpn-instance
vpn-instance-name
N/A
3. Enable RIP on the
interface attached to
the specified network.
network network-address
By default, RIP is disabled on
an interface.
4. Redistribute the VPN
routes.
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | route-policy
route-policy-name | tag tag ] *
By default, no route of any
other routing protocol is
redistributed into RIP.
5. Configure the default
cost value for the
redistributed routes.
default cost value
Optional.
0 by default.
For more information about RIP, see Layer 3—IP Routing Configuration Guide.
Configuring OSPF between MCE and PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an OSPF process for a
VPN instance and enter OSPF
view.
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
N/A