R3102-R3103-HP 6600/HSR6600 Routers MPLS Configuration Guide

68
Ste
p
Command Remarks
4. Submit current tunnel
configuration.
mpls te commit N/A
Configuring route and label recording
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS TE tunnel interface
view.
interface tunnel tunnel-number N/A
3. Enable the system to record
routes or labels when setting
up the tunnel.
• Record routes:
mpls te record-route
• Record routes and labels:
mpls te record-route label
Use either command.
Both route recording and label
recording are disabled by default.
The mpls te record-route label
command is not supported when
the signaling protocol is CR-LDP.
4. Submit current tunnel
configuration.
mpls te commit N/A
Configuring tunnel setup retry
You can configure the system to attempt setting up a tunnel multiple times until it is established
successfully or until the number of attempts reaches the upper limit.
To configure tunnel setup retry:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS TE tunnel interface
view.
interface tunnel tunnel-number N/A
3. Configure maximum number
of tunnel setup retries.
mpls te retry times
Optional.
The default is 10.
4. Configure the tunnel setup
retry interval.
mpls te timer retry seconds
Optional.
The default is 2 seconds.
5. Submit current tunnel
configuration.
mpls te commit N/A
Assigning priorities to a tunnel
Two priorities, setup priority and holding priority, are assigned to paths for MPLS TE to make preemption
decision. For a new path to preempt an existing path, the setup priority of the new path must be greater
than the holding priority of the existing path.