R3102-R3103-HP 6600/HSR6600 Routers MPLS Configuration Guide

7. Create a static route to direct traffic to the MPLS TE tunnel:

[RouterA] ip route-static 3.2.1.2 24 tunnel 0 preference 1

Execute the display ip routing-table command on Router A. You can see a static route entry with

interface Tunnel0 as the outgoing interface.

MPLS TE tunnel using RSVP-TE configuration example

Network requirements

Router A, Router B, Router C, and Router D are running IS-IS and all of them are Level-2 routers.

Use RSVP-TE to create a TE tunnel with 2000 kbps of bandwidth from Router A to Router D, making sure

that the maximum bandwidth of each link that the tunnel traverses is 10000 kbps and the maximum

reservable bandwidth is 5000 kbps.

Figure 25 Network diagram

Device Interface IP address Device Interface IP address

Router A Loop0 1.1.1.9/32

Router C

Loop0

3.3.3.9/32

GE 2/1/1 10.1.1.1/24

GE 2/1/1 30.1.1.1/24

Router B Loop0 2.2.2.9/32 POS 5/1/0 20.1.1.2/24

GE 2/1/1 10.1.1.2/24

Router D

Loop0

4.4.4.9/32

POS

5/1/0 20.1.1.1/24

GE 2/1/1 30.1.1.2/24

Configuration procedure

1. Configure IP addresses and masks for the interfaces according to Figure 25. (Details not shown.)

2. Enable IS-IS to advertise host routes with LSR IDs as destinations:

# Configure Router A.

<RouterA> system-view

[RouterA] isis 1

[RouterA-isis-1] network-entity 00.0005.0000.0000.0001.00

[RouterA-isis-1] quit

[RouterA] interface giabitethernet 2/1/1

[RouterA-GigabitEthernet2/1/1] isis enable 1

[RouterA-GigabitEthernet2/1/1] isis circuit-level level-2

[RouterA-GigabitEthernet2/1/1] quit

[RouterA] interface loopback 0

[RouterA-LoopBack0] isis enable 1