R3303-HP 6600/HSR6600 Routers Configuration Guides Index

OAM. See Ethernet OAM
PIM configuration, MCAST-94
port isolation configuration (on VLAN), LSW-41
port-based VLAN configuration, LSW-94
PPPoE configuration, WAN-69
PPPoEoA, WAN-4
priority mapping configuration, QACL-26
PW packet encapsulation (VPLS), MPLS-210
RRPP configuration, HA-74, HA-82, HA-89
RRPP dual homed rings configuration, HA-96
RRPP intersecting rings configuration, HA-91
RRPP load balanced intersecting rings
configuration, HA-106
RRPP single ring configuration, HA-89
setting LLDP operating mode, LSW-212
setting LLDPDU encapsulation format, LSW-215
statistics group (RMON), NM-99
super VLAN configuration, LSW-115, L SW-117
super VLAN interface configuration, LSW-116
VLAN basic configuration, LSW-91
VLAN configuration, LSW-89
VLAN frame encapsulation, LSW-90
VLAN interface basic configuration, LSW-92
VLAN type, LSW-91
voice VLAN automatic assignment mode port
operation configuration, LSW-124, LSW-126
voice VLAN configuration, LSW-126
voice VLAN interface QoS priority settings
configuration, LSW-123
voice VLAN manual assignment mode port
operation configuration, LSW-125, LSW-128
Ethernet (IPv6 ND attack defense), SEC-530
Ethernet frame header
copying ACL, QACL-9
Ethernet interface
autonegotiation mode, IF-3
changing combo interface active port, IF-2
configuration, IF-1
configuring basic settings, IF-3
configuring jumbo frame support, IF-11
configuring Layer 2 interface statistics polling
interval, IF-7
configuring Layer 2 interface storm control, IF-15
configuring Layer 2 interface storm suppression,
IF-10
configuring Layer 3 interface, IF-16
configuring Layer 3 subinterface, IF-16
configuring link mode, IF-6
configuring loopback testing, IF-5
configuring operating mode for 10-GE interface,
IF-2
configuring physical state change suppression,
IF-5
configuring subinterface, IF-4
displaying, IF-18
displaying subinterface, IF-18
enabling Layer 2 interface loopback detection,
IF-11
enabling subinterface rate statistics collection,
IF-7
full-duplex mode, IF-3
general configuration, IF-1
half-duplex mode, IF-3
maintaining, IF-18
setting Layer 2 interface MDI mode, IF-14
shutting down Ethernet interface, IF-4
testing Layer 2 interface cable connection, IF-14
Ethernet link aggregation
aggregate interface, LSW-12
aggregate interface configuration, LSW-23
aggregate interface description configuration,
LSW-23
aggregate interface link state trap configuration,
LSW-25
aggregate interface MTU configuration, LSW-24