R3303-HP 6600/HSR6600 Routers High Availability Command Reference

97
rpr default-rs
Use rpr default-rs to configure the default RPR ringlet for sending data frames.
Use undo rpr default-rs to restore the default.
Syntax
rpr default-rs { ringlet0 | ringlet1 }
undo rpr default-rs
Default
The default ringlet is Ringlet 0.
Views
Layer 3 RPR logical interface view
Default command level
2: System level
Parameters
ringlet0: Specifies Ringlet 0 as the default ringlet.
ringlet1: Specifies Ringlet 1 as the default ringlet.
Usage guidelines
In case the default ringlet you configured is faulty, the other ringlet works as the default ringlet to forward
data.
Examples
# Specify Ringlet 1 as the default ringlet on Layer 3 RPR logical interface RPR 1.
<Sysname> system-view
[Sysname] interface rpr 1
[Sysname-RPR1] rpr default-rs ringlet1
rpr echo mac
Use rpr echo mac to test the connectivity between the current station and a peer station.
Syntax
rpr echo mac mac-address [ -c c-value | -r { ringlet0 | ringlet1 | reverse } | -s { ringlet0 | ringlet1 } |
-t t-value ] *
Default
Five Echo Request packets are sent. It is the default ringlet in use that sends Echo Response packets and
Echo Request packets. The response timeout time is 10 milliseconds.
Views
Layer 3 RPR logical interface view
Default command level
2: System level