R3303-HP 6600/HSR6600 Routers High Availability Command Reference

101
rpr reversion-mode
Use rpr reversion-mode to set the RPR protection reversion mode.
Use undo rpr reversion-mode to restore the default.
Syntax
rpr reversion-mode { non-revertive | revertive }
undo rpr reversion-mode
Default
Revertive mode applies.
Views
Layer 3 RPR logical interface view
Default command level
2: System level
Parameters
non-revertive: Sets the protection reversion mode to non-revertive, where the station remains in automatic
protection state upon expiration of the WTR timer and does not resume the idle state until a higher
protection request is present on the ring.
revertive: Sets the protection reversion mode to revertive, where the station resumes the idle protection
state once the WTR timer expires.
Examples
# Set the protection reversion mode to non-revertive on Layer 3 RPR logical interface RPR 1.
<Sysname> system-view
[Sysname] interface rpr 1
[Sysname-RPR1] rpr reversion-mode non-revertive
rpr static-rs
Use rpr static-rs to add a static ringlet selection entry, specifying which ringlet is used for sending data
frames destined to the specified MAC address.
Use undo rpr static-rs to remove the entry.
Syntax
rpr static-rs mac-address { ringlet0 | ringlet1 }
undo rpr static-rs mac-address
Default
No static ringlet selection entry exists.
Views
Layer 3 RPR logical interface view
Default command level
2: System level