R3303-HP 6600/HSR6600 Routers Interface Command Reference

195
This command is available only on the interfaces of the HIM-TS8P interface module.
Examples
# Change POS 2/1/0 to a GigabitEthernet interface.
<Sysname> system-view
[Sysname] interface pos 2/1/0
[Sysname-Pos2/1/0] port-type switch GigabitEthernet
Changing port type can result in loss of port configuration. Are you sure to continue?
[Y/N]:y
reset counters interface
Use reset counters interface to clear the statistics of the specified or all POS interfaces.
Syntax
reset counters interface [ pos [ interface-number ] ]
Views
User view
Default command level
2: System level
Parameters
pos interface-number: Specifies a POS interface by its number.
Usage guidelines
Before collecting statistics for an interface within a specific period, you need to clear the existing statistics
of the interface.
• If you do not specify pos, this command clears the statistics of all interfaces.
• If you specify pos but not interface-number, this command clears the statistics of all POS interfaces.
• If you specify both pos and interface-number, this command clears the statistics of the specified
POS interface.
Examples
# Clear the statistics of interface POS 2/1/0.
<Sysname> reset counters interface pos 2/1/0
scramble
Use scramble to enable payload scrambling on the POS interface.
Use undo scramble to disable payload scrambling.
Syntax
scramble
undo scramble
Default
Payload scrambling is enabled.