R3303-HP 6600/HSR6600 Routers Interface Configuration Guide

# Create a 155-Mbps POS interface on E-CPOS 2/0/0.

<RouterC> system-view

[RouterC] controller e-cpos 2/0/0

[RouterC-E-Cpos2/0/0] using oc-3c

# Configure POS interface POS 2/0/0:0.

[RouterC] interface pos2/0/0:0

[RouterC-pos2/0/0:0] ip address 10.110.5.2 255.255.255.0

[RouterC-pos2/0/0:0] mtu 9200

4. Configure Router D:

# Create a 155-Mbps POS interface on E-CPOS 2/0/0.

<RouterD> system-view

[RouterD] controller e-cpos 2/0/0

[RouterD-E-Cpos2/0/0] using oc-3c

# Configure POS interface POS 2/0/0:0.

[RouterD] interface pos2/0/0:0

[RouterD-pos2/0/0:0] ip address 10.110.6.2 255.255.255.0

[RouterD-pos2/0/0:0] mtu 9200

Use the display interface pos 1/0:0 command to check the connectivity status and use the ping

command to check whether the network is reachable.

E-CPOS interface configuration example 2

Network requirements

Configure a 2.5 Gbps E-CPOS interface to carry traffic through 155 Mbps POS channels, as shown

in Figure 23.

Figure 23 Network diagram

Configuration procedure

1. Configure Router A:

# Configure the clock mode of interface E-CPOS 2/0/0.

<RouterA> system-view

[RouterA] controller e-cpos 2/0/0

[RouterA-E-Cpos2/0/0] clock master

# Create two 155 Mbps POS interfaces on interface E-CPOS 2/0/0.

[RouterA-E-Cpos2/0/0] oc-12 4

[RouterA-E-Cpos2/0/0-oc-12-4] oc-3 4

[RouterA-E-Cpos2/0/0-oc-12-4-oc-3-4] using oc-3c

# Configure channelized interface POS 2/0/0/4/4:0.

[RouterA-E-Cpos2/0/0-oc-12-4-oc-3-4] interface pos2/0/0/4/4:0

[RouterA-pos2/0/0/4/4:0] ip address 10.110.4.1 255.255.255.0

2. Configure Router B: