R3303-HP 6600/HSR6600 Routers IP Multicast Command Reference

19
Syntax
igmp-snooping last-member-query-interval interval
undo igmp-snooping last-member-query-interval
Default
The default setting is 1 second.
Views
VLAN view
Default command level
2: System level
Parameters
interval: Sets the IGMP last-member query interval in seconds, in the range of 1 to 5.
Usage guidelines
The IGMP last-member query interval determines the interval for sending IGMP group-specific queries
and the maximum response delay for IGMP group-specific queries in a VLAN.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Examples
# Enable IGMP snooping for VLAN 2 and set the IGMP last-member query interval to 3 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping last-member-query-interval 3
Related commands
• igmp-snooping enable
• last-member-query-interval
igmp-snooping leave source-ip
Use igmp-snooping leave source-ip to configure the source IP address of the IGMP leave messages that
the IGMP snooping proxy sends.
Use undo igmp-snooping leave source-ip to restore the default.
Syntax
igmp-snooping leave source-ip { ip-address | current-interface }
undo igmp-snooping leave source-ip
Default
The source IP address of the IGMP leave messages that the IGMP snooping proxy sends is 0.0.0.0.
Views
VLAN view