R3303-HP 6600/HSR6600 Routers IP Multicast Command Reference

24
Parameters
interval: Specifies an interval in seconds for sending IGMP general queries, in the range of 2 to 300.
Usage guidelines
This command takes effect only if IGMP snooping is enabled in the VLAN.
Examples
# Enable IGMP snooping and set the interval for sending IGMP general queries to 20 seconds in VLAN
2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping query-interval 20
Related commands
• igmp-snooping enable
• igmp-snooping max-response-time
• igmp-snooping querier
• max-response-time
igmp-snooping report source-ip
Use igmp-snooping report source-ip to configure the source IP address for the IGMP reports that the
IGMP snooping proxy sends.
Use undo igmp-snooping report source-ip to restore the default.
Syntax
igmp-snooping report source-ip { ip-address | current-interface }
undo igmp-snooping report source-ip
Default
The source IP address of the IGMP reports that the IGMP snooping proxy sends is 0.0.0.0.
Views
VLAN view
Default command level
2: System level
Parameters
ip-address: Specifies a source address for the IGMP reports that the IGMP snooping proxy sends, which
can be any legal IP address.
current-interface: Specifies the IP address of the current VLAN interface as the source address of IGMP
reports that the IGMP snooping proxy sends. If no IP address has been assigned to the current VLAN
interface, the default IP address 0.0.0.0 is used.