R3303-HP 6600/HSR6600 Routers IP Multicast Command Reference

Usage guidelines

Before you configure this command in a VLAN, enable IGMP snooping in the VLAN.

The source IP address configured in the igmp-snooping report source-ip command also applies when the

simulated host sends IGMP reports.

Examples

# On VLAN 2, enable IGMP snooping and configure the source IP address for IGMP reports that the

I G M P s n o o p i n g p r o x y s e n d s t o 10 .1.1.1.

<Sysname> system-view

[Sysname] igmp-snooping

[Sysname-igmp-snooping] quit

[Sysname] vlan 2

[Sysname-vlan2] igmp-snooping enable

[Sysname-vlan2] igmp-snooping report source-ip 10.1.1.1

Related commands

igmp-snooping enable

igmp-snooping router-aging-time

Use igmp-snooping router-aging-time to set the aging timer for the dynamic router ports in the current

VLAN.

Use undo igmp-snooping router-aging-time to restore the default.

Syntax

igmp-snooping router-aging-time interval

undo igmp-snooping router-aging-time

Default

The aging timer of the dynamic router ports is 105 seconds.

Views

VLAN view

Default command level

2: System level

Parameters

interval: Specifies an aging timer for the dynamic router ports in seconds, in the range of 1 to 1000.