R3303-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Command Reference

171
undo lldp admin-status
Default
The LLDP operating mode is TxRx.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default command level
2: System level
Parameters
disable: Specifies the Disable mode. A port in this mode does not send or receive LLDPDUs.
rx: Specifies the Rx mode. A port in this mode only receives LLDPDUs.
tx: Specifies the Tx mode. A port in this mode only sends LLDPDUs.
txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs.
Usage guidelines
The following matrix shows the command and router compatibility in Layer 2 Ethernet interface view:
Command 6602 HSR6602 6604/6608/6616
lldp admin-status No No
Yes on SAP modules operating in bridge
mode
The following matrix shows the command and router compatibility in port group view:
Command 6602 HSR6602 6604/6608/6616
lldp admin-status No No
Yes on routers installed with the MPU
RPE-X1 or RSE-X1
Examples
# Configure the LLDP operating mode as Rx for GigabitEthernet 4/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 4/0/1
[Sysname-GigabitEthernet4/0/1] lldp admin-status rx
lldp check-change-interval
Use lldp check-change-interval to enable LLDP polling and to set the polling interval.
Use undo lldp check-change-interval to restore the default.
Syntax
lldp check-change-interval interval
undo lldp check-change-interval
Default
LLDP polling is disabled.