R3303-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Command Reference

172
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default command level
2: System level
Parameters
interval: Sets the LLDP polling interval in the range of 1 to 30 seconds.
Usage guidelines
The following matrix shows the command and router compatibility in Layer 2 Ethernet interface view:
Command 6602 HSR6602 6604/6608/6616
lldp check-change-interval No No
Yes on SAP modules
operating in bridge mode
The following matrix shows the command and router compatibility in port group view:
Command 6602 HSR6602 6604/6608/6616
lldp check-change-interval
No No
Yes on routers installed with
the MPU RPE-X1 or RSE-X1
Examples
# Enable LLDP polling on GigabitEthernet 4/0/1, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface GigabitEthernet 4/0/1
[Sysname-GigabitEthernet4/0/1] lldp check-change-interval 30
lldp compliance admin-status cdp
Use lldp compliance admin-status cdp to configure the operating mode of CDP-compatible LLDP on a
port or all ports in a port group.
Use undo lldp compliance admin-status cdp to restore the default.
Syntax
lldp compliance admin-status cdp { disable | txrx }
undo lldp compliance admin-status cdp
Default
CDP-compatible LLDP operates in disable mode.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default command level
2: System level