R3303-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Configuration Guide

185
Configuring a downlink policy
To configure a downlink policy to map SVLANs back to CVLANs:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure one class for an
SVLAN.
a. Create a class and enter class view:
traffic classifier tcl-name [ operator
{ and | or } ]
b. Configure an SVLAN as the match
criterion:
if-match service-vlan-id vlan-id
c. Return to system view:
quit
Repeat this step to
configure one class for
each SVLAN.
3. Configure one behavior for a
CVLAN.
a. Create a traffic behavior and enter
traffic behavior view:
traffic behavior behavior-name
b. Configure a CVLAN marking action:
remark customer-vlan-id vlan-id
c. Return to system view:
quit
Repeat this step to
configure one behavior
for each CVLAN.
4. Create a QoS policy and
enter QoS policy view.
qos policy policy-name N/A
5. Associate the class with the
behavior to map the SVLAN
to the CVLAN.
classifier tcl-name behavior behavior-name
Repeat this step to
create other
CVLAN-to-SVLAN
mappings.
Configuring the customer-side port
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Ethernet interface view.
• Enter Layer 2 Ethernet interface view:
interface interface-type
interface-number
• Ethernet port group view:
port-group manual port-group-name
N/A
3. Configure the link type of the
port.
• Configure the port as a trunk port:
port link-type trunk
• Configure the port as a hybrid port:
port link-type hybrid
Use one of the commands.
The default link type of an
Ethernet port is access.