R3303-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

110
• Per-packet load balancing—Distributes packets evenly across all selected interfaces by using the
round-robin method.
Example
# Configure per-packet load balancing for HDLC link bundle interface 1.
<Sysname> system-view
[Sysname] interface hdlc-bundle 1
[Sysname-HDLC-bundle1] bundle load-balance per-packet
bundle max-active links
Use bundle max-active links to limit the number of selected interfaces in an HDLC link bundle.
Use undo bundle max-active links to remove the limit.
Syntax
bundle max-active links number
undo bundle max-active links
Default
The maximum number of selected member interfaces allowed in an HDLC link bundle is not set.
Views
HDLC link bundle interface view
Default command level
2: System level
Parameters
number: Maximum number of selected member interfaces allowed in an HDLC link bundle. The value
range for this argument is 1 to 8.
Usage guidelines
The value specified using this command cannot be smaller than that specified using the bundle
min-active links command.
Use the undo bundle max-active links command together with the bundle member-priority command to
make sure that the peer interfaces of a link always have the same selected status. Your communication
will fail if one end is selected but the other end is unselected.
Examples
# Limit the number of selected member interfaces in HDLC link bundle 1 to 8.
<Sysname> system-view
[Sysname] interface hdlc-bundle 1
[Sysname-Hdlc-bundle1] bundle max-active links 8
Related commands
• bundle min-active links
• bundle member-priority