R3303-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

27
Related commands
• ip-precedence
• pvc
pvc max-number
Use pvc max-number to set the maximum number of PVCs allowed on an ATM interface.
Use undo pvc max-number to restore the default.
Syntax
pvc max-number max-number
undo pvc max-number
Views
ATM main interface view
Default command level
2: System level
Parameters
max-number: Maximum number of PVCs allowed on the ATM interface. The value range varies by the
type of physical interface, as shown in Table 9.
Table 9 Maximum nu
mber of PVCs supported on ATM interfaces
Interface t
yp
e Maximum number Default
ADSL 1 to 32 32
GSHDSL 1 to 32 32
ATM OC3 1 to 1024 1024
ATM25 1 to 256 256
ATM E3 1 to 1024 1024
ATM T3 1 to 1024 1024
Usage guidelines
The maximum number of PVCs allowed varies with interface type.
The maximum number specified in this command is the total number of the PVCs available to both ATM
main interface and the subinterfaces.
This command applies to both ATM main interface and subinterface. However, the command itself is
available only in ATM main interface view.
Examples
# Configure ATM 1/0/1 interface to support up to 1024 PVCs.
<Sysname> system-view
[Sysname] interface atm 1/0/1
[Sysname-Atm1/0/1] pvc max-number 1024