R3303-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

61
• 6602 routers support one-dimensional MP-group interface numbers in the range of 0 to 1023.
• HSR6602, 6604, 6608, and 6616 routers support three-dimensional MP-group interface numbers,
in the format of X/Y/Z:
{ X indicates the number of the slot where the base card resides. The value range depends on the
device model.
{ Y indicates the number of the slot where the subcard resides. The value range depends on the
device model.
{ Z indicates the interface number on the subcard. The value range is 0 to 1023.
Usage guidelines
You must use the interface mp-group command together with the ppp mp mp-group command. You can
execute the two commands in either order.
MP-group interfaces do not support cross-base-card binding.
Examples
On an 6602 router:
# Create interface MP group 3.
<Sysname> system-view
[Sysname] interface mp-group 3
[Sysname-Mp-group3]
On an HSR6602 /6604/6608/6616 router:
# Create interface MP group 1/0/0.
<Sysname> system-view
[Sysname] interface mp-group 1/0/0
[Sysname-Mp-group1/0/0]
interface virtual-template
Use interface virtual-template to create a VT and enter VT view. If the VT already exists, enter its view
directly.
Use undo interface virtual-template to remove a VT.
Syntax
interface virtual-template number
undo interface virtual-template number
Views
System view
Default command level
2: System level
Parameters
number: VT number, in the range of 0 to 1023.