R3303-HP 6600/HSR6600 Routers Layer 3 - IP Routing Command Reference

381
Usage guidelines
After sending a LSA to its neighbor, the device waits for an acknowledgement. If receiving no
acknowledgement after the LSA retransmission interval elapses, it retransmits the LSA.
The LSA retransmission interval should not be too small for avoidance of unnecessary retransmissions.
Examples
# Configure the LSA retransmission interval on an interface in instance 1 as 12 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-Gigabitethernet2/1/1] ospfv3 timer retransmit 12 instance 1
ospfv3 timer poll
Use ospfv3 timer poll to set the poll interval on an NBMA interface.
Use undo ospfv3 timer poll to restore the default value.
Syntax
ospfv3 timer poll seconds [ instance instance-id ]
undo ospfv3 timer poll [ seconds ] [ instance instance-id ]
Default
The poll interval is 120 seconds.
Views
Interface view
Default command level
2: System level
Parameters
seconds: Specifies the poll interval in seconds, in the range of 1 to 65535.
instance-id: Specifies an interface instance by its ID in the range of 0 to 255. The default is 0.
Examples
# Set the poll timer interval on the current interface to 130 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-Gigabitethernet2/1/1] ospfv3 timer poll 130
ospfv3 trans-delay
Use ospfv3 trans-delay to configure the transmission delay for an interface with an instance ID.
Use undo ospfv3 trans-delay to restore the default.
Syntax
ospfv3 trans-delay seconds [ instance instance-id ]
undo ospfv3 trans-delay [ seconds ] [ instance instance-id ]