R3303-HP 6600/HSR6600 Routers Layer 3 - IP Routing Command Reference

53
rip default-route
Use rip default-route to configure the RIP interface to advertise a default route with the specified metric.
Use undo rip default-route to disable the RIP interface from sending a default route.
Syntax
rip default-route { { only | originate } [ cost cost ] | no-originate }
undo rip default-route
Default
A RIP interface can advertise a default route if the RIP process is configured with default route
advertisement.
Views
Interface view
Default command level
2: System level
Parameters
only: Advertises only a default route.
originate: Advertises a default route and other routes.
cost: Specifies a cost for the default route, in the range of 1 to 15. The default is 1.
no-originate: Advertises routes other than a default route.
Usage guidelines
A RIP router configured to advertise a default route will not receive any default routes from RIP neighbors.
Examples
# Configure GigabitEthernet 2/1/1 to advertise only a default route with a metric of 2.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] rip default-route only cost 2
Related commands
default-route
rip input
Use rip input to enable the interface to receive RIP messages.
Use undo rip input to disable the interface from receiving RIP messages.
Syntax
rip input
undo rip input
Default
An interface is enabled to receive RIP messages.