R3303-HP 6600/HSR6600 Routers Layer 3 - IP Routing Configuration Guide

140
• RFC 3784, IS-IS extensions for Traffic Engineering
• RFC 3847, Restart signaling for IS-IS
IS-IS configuration task list
Task Remarks
Configuring IS-IS
basic functions
Enabling IS-IS
Required. Configuring the IS level and circuit level
Configuring the network type of an interface as P2P
Configuring IS-IS
routing information
control
Configuring IS-IS link cost Optional.
Specifying a priority for IS-IS Required.
Configuring the maximum number of ECMP routes Optional.
Configuring IS-IS route summarization Optional.
Advertising a default route Optional.
Configuring IS-IS route redistribution Optional.
Configuring IS-IS route filtering Optional.
Configuring IS-IS route leaking Optional.
Configuring a DIS
priority for an
interface
Specifying intervals for sending IS-IS hello and CSNP packets Optional.
Specifying the IS-IS hello multiplier Optional.
Configuring a DIS priority for an interface Optional.
Disabling an interface from sending/receiving IS-IS packets Optional.
Disabling hello source address check for a PPP interface Optional.
Enabling an interface to send small hello packets Optional.
Configuring LSP parameters Optional.
Configuring SPF parameters Optional.
Assigning a high priority to IS-IS routes Optional.
Setting the LSDB overload bit Optional.
Configuring system ID to host name mappings Optional.
Enabling the logging of neighbor state changes Optional.
Enhancing IS-IS
network security
Configuring neighbor relations
hip authentication Optional.
Configuring area authentication Optional.
Configuring routing domain authentication Optional.
Configuring IS-IS GR Optional.
Configuring IS-IS NSR Optional.
Configuring IS-IS FRR Optional.
Enabling IS-IS SNMP trap Optional.