R3303-HP 6600/HSR6600 Routers Layer 3 - IP Services Command Reference

292
For an HSR6602 /6604/6608/6616 router, do not use the service slot command to specify the main
board for forwarding traffic on the current interface because all services and traffic are forwarded on the
service card.
If the tunnel source is a Layer 3 aggregate interface, you must execute this command to specify the
service card for forwarding traffic on the tunnel interface.
The following matrix shows the command and router compatibility:
Command 6602 HSR6602 6604/6608/6616
service No Yes Yes
Examples
# Specify service card 2 for forwarding traffic on interface Tunnel 200.
<Sysname> system-view
[Sysname] interface tunnel 200
[Sysname-Tunnel200] service slot 2
shutdown
Use shutdown to shut down a tunnel interface.
Use undo shutdown to bring up a tunnel interface.
Syntax
shutdown
undo shutdown
Default
A tunnel interface is in the up state.
Views
Tunnel interface view
Default command level
2: System level
Examples
# Shut down interface Tunnel 1.
<Sysname> system-view
[Sysname] interface tunnel 1
[Sysname-Tunnel1] shutdown
source
Use source to specify the source address or source interface for the tunnel interface.
Use undo source to restore the default.
Syntax
source { ip-address | ipv6-address | interface-type interface-number }