R3303-HP 6600/HSR6600 Routers MPLS Configuration Guide

186
[PE2] interface pos 5/1/1
[PE2-POS5/1/1] link-protocol ppp
[PE2-POS5/1/1] mpls static-l2vc destination 192.2.2.2 transmit-vpn-label 200
receive-vpn-label 100
[PE2-POS5/1/1] quit
5. Configure CE 2:
# Configure the link protocol as PPP on interface POS 5/1/0 (the interface connected to PE 2),
and configure an IP address for the interface.
<Sysname> system-view
[Sysname] sysname CE2
[CE2] interface pos 5/1/0
[CE2-POS5/1/0] link-protocol ppp
[CE2-POS5/1/0] ip address 100.1.1.2 24
Verifying the configuration:
# Display static VC information on PE 1. The output shows that a VC has been established.
[PE1] display mpls static-l2vc
Total connections: 1, 1 up, 0 down
ce-intf state destination tr-label rcv-label tnl-policy
POS5/1/0 up 192.3.3.3 100 200 -
# Display static VC information on PE 2. The output shows that a VC has been established.
[PE2] display mpls static-l2vc
Total connections: 1, 1 up, 0 down
ce-intf state destination tr-label rcv-label tnl-policy
POS5/1/1 up 192.2.2.2 200 100 -
# Ping CE 2 from CE 1. The output shows that CE 1 and CE 2 can ping each other.
[CE1] ping 100.1.1.2
PING 100.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=150 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=130 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=130 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=140 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=80 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 80/126/150 ms
Example for configuring Martini MPLS L2VPN with the VC type
of PPP
Network requirements
CEs are connected to PEs through serial interfaces, and the data link layer uses PPP.
Establish a Martini VC, so CE 1 and CE 2 can exchange Layer 2 packets across the backbone.