R3303-HP 6600/HSR6600 Routers MPLS Configuration Guide

30
Ste
p
Command Remarks
2. Enable the MPLS trap.
snmp-agent trap enable mpls
By default, the MPLS trap is
disabled.
For more information about the
command, see the snmp-agent
trap enable command in Network
Management and Monitoring
Command Reference.
Displaying and maintaining MPLS
Use the commands in this section to verify MPLS configuration and maintain MPLS statistics.
Displaying MPLS operation
Task Command Remarks
Display information about one or
all interfaces with MPLS enabled.
display mpls interface
[ interface-type interface-number ]
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display information about ILM
entries.
display mpls ilm [ label ] [ verbose ]
[ slot slot-number ] [ | { begin |
exclude | include }
regular-expression ]
Available in any view.
Display information about
specified MPLS labels or all labels.
display mpls label { label-value1 [ to
label-value2 ] | all } [ | { begin |
exclude | include }
regular-expression ]
Available in any view.
Display information about LSPs.
display mpls lsp [ incoming-interface
interface-type interface-number ]
[ outgoing-interface interface-type
interface-number ] [ in-label
in-label-value ] [ out-label
out-label-value ] [ asbr |
[ vpn-instance vpn-instance-name ]
[ protocol { bgp | bgp-ipv6 | crldp |
ldp | rsvp-te | static | static-cr } ] ]
[ egress | ingress | transit ]
[ { exclude | include } dest-addr
mask-length ] [ verbose ] [ | { begin |
exclude | include }
regular-expression ]
Available in any view.
Display LSP statistics.
display mpls lsp statistics [ | { begin
| exclude | include }
regular-expression ]
Available in any view.