HP HSR6600 Router and Router Processing modules series - A6600_HSR6602-CMW520-R3102 Release Notes

15
 Condition: This symptom might occur when the following conditions exist:
 More than three line cards are installed and at least one line card is FIP-200.
 Traffic between line cards exists.
 A line card is removed or rebooted.
RTD063812
 Symptom: The CLI responds slowly to a user that has logged in through console, Telnet, or SSH.
 Condition: This symptom occurs when the CPU usage is 100% due to large numbers of route
updates or withdrawal requests.
RTD063963
 Symptom: When access the hh3cUserPassword node of hh3cUserInfoTable by SNMP, the device
return the user's password.
 Condition: Access the hh3cUserPassword node of hh3cUserInfoTable by SNMP.
Resolved Problems in CMW520-R2604P05
RTD063021
 Symptom: LACP might fail to be enabled on a port.
 Condition: This symptom might occur on a port if the following procedure is performed:
 Remove the port from a link aggregation group when the port is shut down.
 Enable the port and add it another link aggregation group.
 Update the members in the original link aggregation group.
RTD063369
 Symptom: Some AAA servers cannot filter users by IMSI and SN.
 Condition: This symptom might occur when user filtering based on IMSI and SN is configured on
some AAA servers.
RTD063390
 Symptom: BGP route flaps might occur if many BGP routes with multiple attributes are updated
through a complicated routing policy.
 Condition: This symptom might occur if many BGP routes with multiple attributes are updated
through a complicated routing policy.
RTD063504
 Symptom: An A6600 router configured with an ACG card cannot be pinged from a directly
connected PC, and the running routing protocol cannot create neighbors.
 Condition: This symptom might occur if an ACFP policy with the source or destination port specified
as "any" is configured.
Resolved Problems in CMW520-R2604P04
RTD062419
 Symptom: The tunnel interface cannot deal with the bandwidth change.