HP HSR6600 Router and Router Processing modules series - A6600_HSR6602-CMW520-R3102 Release Notes

21
RTD57526
 Symptom: A6600 router cannot deal with the message of VPLS MAC Address Withdraw, LDP flush
frequently.
 Condition: A6600 router connects with some special device through VPLS.
RTD57527
 Symptom: The A6600 router restart automatically when display the statistics information of NATPT.
 Condition: NATPT is configured in too much interface.
RTD57528
 Symptom: Display the IPv6 information of the interface, A6600 router restarts automatically.
 Condition: IPv6 is configured at 10GE interface.
RTD57529
 Symptom: The BGP neighborhoods flush frequently.
 Condition: The usage rate of CPU is too high.
Resolved Problems in CMW520-R2603P02
RTD56361
 Symptom: The RIP route bypass the link cannot be deleted normally
 Condition: RIP and BFD are configured, the data link is single pass, send direction is normal, but
cannot receive data.
RTD56470
 Symptom: If the burst data package is too large, the amount of dropped package is too large.
 Condition: CBQ is configured at A6600 router.
RTD56636
 Symptom: The data link cannot up.
 Condition: The CPOS module work at t1 mode, and ‘frame-format sf’ is configured.
RTD56647
 Symptom: The MPU restart automatically.
 Condition: It happens when BGP and MSDP frequently flap at the same time.
1. Both BGP and MSDP protocols are configured on the router
2. The more MSDP and BGP neighbors there are, when both neighbors flap, the more likely this
trouble would happen.
3. If MSDP and BGP neighbors flap frequently, the more likely this trouble would happen.
RTD56718
 Symptom: The device cannot connect with some special LAC device.
 Condition: A6600 routers work as LNS.