HP HSR6600 Router Series - HP A6600_HSR6602-CMW520-R3103P04-RU Release Notes

Resolved Problems in CMW520-R3103P02

RTD066142

 Symptom: After the OSPF default route is deleted, the standby MPU prints the message "The default

route has been changed or deleted, protocol is OSPF", which should be output by the active MPU.

 Condition: This symptom occurs when the following conditions exist:

The router has two MPUs.

OSPF NSR is enabled.

An OSPF default route exists.

RTD066144

 Symptom: When the DHCP relay agent on the A6600 receives a DHCP packet in which the length

value in Option 82 is larger than the actual field length, the A6600 reboots.

 Condition: This symptom occurs when the DHCP relay agent on the A6600 receives a DHCP packet

in which the length value in Option 82 is larger than the actual field length.

RTD066403

 Symptom: When session control is enabled on the AAA server and a RADIUS key is configured on

A6600, users might fail to get online.

 Condition: This symptom might occur when session control is enabled on the AAA server and a

RADIUS key is configured on A6600.

RTD066571

 Symptom: When the security policy server is enabled on IMC and the A6600 acts as the portal

gateway, an iNode client passes security policy authentication and can access the network. After

a certain time, the iNode client fails to pass security policy authentication and cannot access the

network.

 Condition: This symptom occurs when the security policy server is enabled on IMC and the A6600

acts as the portal gateway.

Resolved Problems in CMW520-R3103P01

RTD065718

 Symptom: After portal authentication has run for one day, it stops working, and users can access

the network without being authenticated. This problem might occur earlier if more traffic exists.

 Condition: This symptom can be seen after portal authentication has run for one day or less.

RTD066128

 Symptom: After a distributed device MPU is rebooted or its line card is rebooted, logical interface

cannot pass the IPSec negotiation.

 Condition: This symptom might occur after MPU or line card rebooted, and the IPSEC is configured

on the logical interface.

RTD065758

 Symptom: The port rate displayed on the network management software is not correct.