R3102-R3103-HP 6600/HSR6600 Routers Fundamentals Configuration Guide

141
# Configure the device to shut down GigabitEthernet 3/0/3 at 18:00 on working days every week.
[Sysname-job-pc3] time 2 repeating at 18:00 week-day mon tue wed thu fri command shutdown
[Sysname-job-pc3] quit
# Display information about scheduled jobs.
[Sysname] display job
Job name: pc1
Specified view: GigabitEthernet3/0/1
Time 1: Execute command undo shutdown at 08:00 Mondays Tuesdays Wednesdays Thursdays
Fridays
Time 2: Execute command shutdown at 18:00 Mondays Tuesdays Wednesdays Thursdays Fridays
Job name: pc2
Specified view: GigabitEthernet3/0/2
Time 1: Execute command undo shutdown at 08:00 Mondays Tuesdays Wednesdays Thursdays
Fridays
Time 2: Execute command shutdown at 18:00 Mondays Tuesdays Wednesdays Thursdays Fridays
Job name: pc3
Specified view: GigabitEthernet3/0/3
Time 1: Execute command undo shutdown at 08:00 Mondays Tuesdays Wednesdays Thursdays
Fridays
Time 2: Execute command shutdown at 18:00 Mondays Tuesdays Wednesdays Thursdays Fridays
Unmounting a hot-swappable card or subcard
IMPORTANT:
• Unmounting a card or subcard causes service interruption.
• You can use this feature to unmount only hot-swappable card or subcard. To install or remove a
non-hot-swappable card, you must power off the device.
To install a hot-swappable card or subcard, you only need to insert it to a slot in the device. To remove
a hot-swappable card or subcard, however, you must first unmount the card.
To unmount a hot-swappable card or subcard, execute the following command in user view:
Task Command Remarks
Unmount a hot-swappable card or
subcard.
• On an 6602:
remove slot slot-number
• On an HSR6602, 6604, 6608,
or 6616:
remove slot slot-number
[ subslot subslot-number ]
These commands apply to only
hot-swappable cards and
subcards. To install or remove
non-hot-swappable cards and
subcards, you must power off the
device.
Specifying a poweron priority for a card
The following matrix shows the feature and router compatibility: