R3102-R3103-HP 6600/HSR6600 Routers High Availability Configuration Guide

102
[RouterC-rrpp-domain1] ring 5 node-mode assistant-edge edge-port gigabitethernet
3/0/4
[RouterC-rrpp-domain1] ring 5 enable
[RouterC-rrpp-domain1] quit
# Enable RRPP.
[RouterC] rrpp enable
4. Configure Router D:
# Create VLANs 1 through 30, map these VLANs to MSTI 1, and activate the MST region
configuration.
<RouterD> system-view
[RouterD] vlan 1 to 30
[RouterD] stp region-configuration
[RouterD-mst-region] instance 1 vlan 1 to 30
[RouterD-mst-region] active region-configuration
[RouterD-mst-region] quit
# Set the physical state change suppression interval to 0 seconds on GigabitEthernet 3/0/1
through GigabitEthernet 3/0/4. Disable the spanning tree feature, configure the four ports as
trunk ports, and assign them to VLANs 1 through 30.
[RouterD] interface gigabitethernet 3/0/1
[RouterD-GigabitEthernet3/0/1] link-delay 0
[RouterD-GigabitEthernet3/0/1] undo stp enable
[RouterD-GigabitEthernet3/0/1] port link-type trunk
[RouterD-GigabitEthernet3/0/1] port trunk permit vlan 1 to 30
[RouterD-GigabitEthernet3/0/1] quit
[RouterD] interface gigabitethernet 3/0/2
[RouterD-GigabitEthernet3/0/2] link-delay 0
[RouterD-GigabitEthernet3/0/2] undo stp enable
[RouterD-GigabitEthernet3/0/2] port link-type trunk
[RouterD-GigabitEthernet3/0/2] port trunk permit vlan 1 to 30
[RouterD-GigabitEthernet3/0/2] quit
[RouterD] interface gigabitethernet 3/0/3
[RouterD-GigabitEthernet3/0/3] link-delay 0
[RouterD-GigabitEthernet3/0/3] undo stp enable
[RouterD-GigabitEthernet3/0/3] port link-type trunk
[RouterD-GigabitEthernet3/0/3] port trunk permit vlan 1 to 30
[RouterD-GigabitEthernet3/0/3] quit
[RouterD] interface gigabitethernet 3/0/4
[RouterD-GigabitEthernet3/0/4] link-delay 0
[RouterD-GigabitEthernet3/0/4] undo stp enable
[RouterD-GigabitEthernet3/0/4] port link-type trunk
[RouterD-GigabitEthernet3/0/4] port trunk permit vlan 1 to 30
[RouterD-GigabitEthernet3/0/4] quit
# Create RRPP domain 1, configure VLAN 4092 as the primary control VLAN of RRPP domain 1,
and configure the VLANs mapped to MSTI 1 as the protected VLANs of RRPP domain 1.
[RouterD] rrpp domain 1
[RouterD-rrpp-domain1] control-vlan 4092
[RouterD-rrpp-domain1] protected-vlan reference-instance 1