R3102-R3103-HP 6600/HSR6600 Routers High Availability Configuration Guide

12
Task
Remarks
Configuring the Ethernet OAM connection detection timers
Required
Configuring link
monitoring
Configuring errored symbol event detection
Optional
Configuring errored frame event detection
Optional
Configuring errored frame period event detection
Optional
Configuring errored frame seconds event detection
Optional
Configuring Ethernet
OAM remote
loopback
Enabling Ethernet OAM remote loopback in user view
Optional
Enabling Ethernet OAM remote loopback in system view
Optional
Enabling Ethernet OAM remote loopback in Ethernet port view
Optional
Rejecting the Ethernet OAM remote loopback request from a
remote port
Optional
Configuring basic Ethernet OAM functions
To set up an Ethernet OAM connection between two Ethernet OAM entities, you must set at least one
entity to operate in active mode. Only in active mode can an Ethernet OAM entity initiate OAM
connection.
To change the Ethernet OAM mode on an Ethernet OAM-enabled port, first disable Ethernet OAM on
the port.
To configure basic Ethernet OAM functions:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter Ethernet port view.
interface interface-type
interface-number
N/A
3. Set the Ethernet OAM
mode.
oam mode { active |
passive }
Optional.
The default is active Ethernet OAM mode.
4. Enable Ethernet OAM on
the current port.
oam enable
Ethernet OAM is disabled by default.
Configuring the Ethernet OAM connection
detection timers
After an Ethernet OAM connection is established, the Ethernet OAM entities exchange Information
OAMPDUs at the handshake packet transmission interval to detect the availability of the Ethernet
OAM connection. If an Ethernet OAM entity receives no Information OAMPDU within the Ethernet
OAM connection timeout time, the Ethernet OAM connection is considered disconnected.
By adjusting the handshake packet transmission interval and the connection timeout timer, you can
change the detection time resolution for Ethernet OAM connections.