R3102-R3103-HP 6600/HSR6600 Routers Interface Configuration Guide

60
To configure a CPOS interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter CPOS interface view.
controller cpos cpos-number N/A
3. Set the interface description.
description text
Optional.
By default, the description of a
CPOS interface is interface name
Interface, for example,
Cpos5/1/0 Interface.
4. Set the framing format.
frame-format { sdh | sonet }
Optional.
SDH by default.
5. Set the clock mode.
clock { master | slave }
Optional.
Slave by default.
6. Set the loopback mode.
loopback { local | remote }
Optional.
Disabled by default.
7. Configure the AUG
multiplexing mode.
multiplex mode { au-3 | au-4 }
Optional.
Available only in SDH framing.
AU-4 by default.
8. Configure the SOH and
higher-order path overhead
bytes
flag { c2 path-number c2-value | s1
s1-value | s1s0 path-number
s1s0-value }
Optional.
flag { j0 | j1 path-number } { sdh |
sonet } flag-value
9. Set the physical state change
suppression interval on the
interface.
link-delay seconds
Optional.
By default, physical state change
suppression interval is disabled on
the interface.
10. Set the intended bandwidth
for the CPOS interface.
bandwidth bandwidth-value Optional.
11. Restore the default settings for
the CPOS interface.
default Optional.
12. Shut down the CPOS
interface.
shutdown
Optional.
Up by default.
13. Set the signal degrade (SD) or
signal fail (SF) alarm threshold
for the interface.
threshold { sd | sf } value
Optional.
By default, the SD alarm threshold
is 10e-6 (the value argument is 6),
and the SF alarm threshold is
10e-3 (the value argument is 3).