R3102-R3103-HP 6600/HSR6600 Routers Interface Configuration Guide

79
Displaying and maintaining E-CPOS interfaces
Task Command Remarks
Display information about all
channels of the specified E-CPOS
interface.
display controller e-cpos [ e-cpos-number ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Display information about the
E3/T3 channels of the specified
E-CPOS interface.
display interface serial interface-number [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Display information about the POS
channels of the specified E-CPOS
interface.
display interface pos interface-number [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Clear the controller counter of the
specified E-CPOS interface.
reset counters controller e-cpos
interface-number
Available in user view.
E-CPOS interface configuration examples
E-CPOS interface configuration example 1
Network requirements
As shown in Figure 21,
• Router A and Router B provide 622 Mbps E-CPOS interfaces, while Router C and Router D provide
155 Mbps E-CPOS interfaces.
• Channelized interface POS 2/0/0/1:0 of Router A is connected to channelized interface POS
2/0/0/1:0 of Router B through an SDH transmission device.
• Channelized interface POS 2/0/0/2:0 of Router A is connected to interface POS 2/0/0 of Router
C through an SDH transmission device.
• Channelized interface POS 2/0/0/2:0 of Router B is connected to interface POS 2/0/0 of Router
D through an SDH transmission device.
• Each interface uses PPP on the data link layer. All routers use the clock of the SDH transmission
device. The MTU of each interface is 9200 bytes.