R3102-R3103-HP 6600/HSR6600 Routers IP Multicast Configuration Guide

393
Local
p
arameter Peer
p
arameter Ne
g
otiation result
both both
Both the ORF sending and receiving capabilities
are enabled locally and on the peer.
Configuring the maximum number of equal-cost routes for
load-balancing
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 MBGP address
family view.
ipv6-family multicast N/A
4. Configure the maximum
number of equal-cost routes
for load balancing.
Balance [ ebgp | ibgp ] number
By default, load balancing is
disabled.
Configuring a large scale IPv6 MBGP network
Configuration prerequisites
Before you configure the following tasks, you must configure basic IPv6 MBGP functions.
Configuring an IPv6 MBGP peer group
For easy management and configuration, you can organize some IPv6 MBGP peers that have the same
route update policy into a peer group. A policy configured for a peer group applies to all the members
in the group.
IMPORTANT:
• To create an IPv6 MBGP peer group, you must enable an existing IPv6 unicast peer group in IPv6 MBGP
address family view.
• Before adding an IPv6 MBGP peer to the IPv6 MBGP peer group, you must add the correspondin
g
IPv6
BGP unicast peer to the corresponding IPv6 BGP unicast peer group.
To configure an IPv6 MBGP peer group:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family view.
ipv6-family N/A
4. Create an IPv6 BGP peer group.
group ipv6-group-name [ external |
internal ]
N/A